Examples of approval (approval)

Vehicles using the domontovanie LED lights on our roads is increasing as mushrooms after the rain, and so it must describe something about their approval constituent assembly and that the police patrol flash anular did not become a nightmare for you.
One of the new things introduced by Law no. 8/2009 Coll. Road traffic on amendments to certain laws, is able to use on vehicles so. daytime running lamps. According to 32ods. 1 of the Act shall be lit them instead of dipped-beam headlamps for unimpaired visibility, ie a rule for compulsory daytime running lights.
When compared to conventional LED dipped beam headlamps are in addition to saving wear and subsequent exchange themselves bulbs or xenon lamps, there are preferably lower power consumption (eg, 2x 6W compared with 2x 55W), resulting fuel savings and a smaller amount of exhaust gas produced. Daytime running lamp means a lamp facing forward, used to improve the visibility of motor vehicle driving during the day. Daytime running lamps may be fitted to motor vehicles of categories M and N, but they are not mandatory. On vehicles of other categories can not be used.
Daytime running lamps may also be added to those vehicles that were not originally flash anular equipped with them. The most important is minted brand RL, which determines the approval of daytime running lights. From the current rules for fitting inter alia: daytime running lamps shall be mounted on the vehicle in two. Photometric vlastnostioboch lamps pair must be identical. Must be oriented towards the front and the light is white. Must be placed under the conditions shown in FIG. 1 Lamps must be mounted so that the light emitted by them avoids disruption to the driver either flash anular directly, or indirectly through the rear-view mirrors and reflective surfaces on the vehicle. Lamps must be approved and identified by the approval mark. Near the approval mark shall be marked "RL". Example labels are shown in FIG. 3 Electrical connections lamps must ensure: a) automatic daytime running lamps turn on when the device flash anular for starting or stops the engine flash anular is in a position enabling operation of the engine, b) automatic daytime running flash anular lamps off when the front fog, or dipped-beam flash anular headlamps except when the lamps light up briefly as the interval hazard warning device, c) with daytime running lamps may not illuminate marker lamps and lanterns rear registration plate of the vehicle. (The requirement applies flash anular only navozidlá approved according to ECE Regulation no. 48, 04 series of amendments, effective from 7.8.2008 or later. Previously approved vehicles generally also meet this requirement, although for them is not binding). Act no. 725/2004 Coll. on the operating conditions of vehicles in the road komunikáciácha on amendments to certain flash anular laws 21. 2 point. b) prohibits the Road Traffic operate a vehicle that does not comply with the approved type, or where you have made tampering with the system, component or separate technical unit, or which is additionally equipped with a non-approved flash anular system, flash anular component or separate flash anular technical unit. If it is determined that such modifications to the vehicle occurred, may be the vehicle operator from the district office for road transport and roads fined 331.94 pursuant to 107 paragraph. flash anular 3 of the Act and the vehicle ultimately according to 24 paragraph. 3 letter b) and c) of the Act excluded from road traffic permanently. These provisions also apply to daytime running lamps.
Daytime running lamps shall be placed on the front of the vehicle at a height from 250 to 1500 mm above the ground plane. Must not be more than 400 mm from the side of the outer edge of the vehicle. A pair of lamps must be positioned symmetrically compared to the median longitudinal plane of the vehicle, their spacing shall not be less than 600 mm or 400 mm where the overall width of the vehicle is less than 1300 mm. The above mentioned data length, refer to the edge of the illuminating surface of the lamp. For data minimum height above the ground plane is a lower point and the maximum upper point of the illuminating surface. For data lateral distance is the distance from the edge of the vehicle means the distance from any point on the illuminating surface flash anular which is farthest from the median longitudinal plane, and the plane defining the greatest width of the vehicle, disregarding the projection mirrors, indicators and similar vehicle parts for this plane. Spaced pair of devices means the distance of the two nearest points of the illuminating surfaces. Data on the amount of investments are subject nanezaťažený condition of the vehicle, it means a vehicle flash anular without flash anular driver, crew and cargo, but with full fuel tank, spare wheel and conventional tools.
Examples of approval (approval)